How to Sublimate Coasters

Substrate: Hardboard

Products: 4028, 1009, 4026, 4597, 4889, 5677, 5822, 3009e, 4933, 4942, 4934

Learn how to sublimate Unisub coasters. Coasters make fun, practical decor pieces you can adorn with photos and text.

Coasters are available in a variety of shapes and sizes and are all made with our hardboard or wood material. All of our coasters, including raw back, cork back, and premium coasters, have the same instructions for sublimation. If you are searching for coaster templates, graphics, or other assets click here

What You Need

instructions

Step 1. Get Your Heat Press Ready

Turn on your heat press. We recommend pressing all of our products at 385°F / 195°C. Be sure to lay a piece of protective paper on the bottom of the press.

Step 2. Prep Your Coaster

Remove any film that may be on the surface of the coaster. Film may be clear and can be difficult to see at first. Clean off the front of the coaster with a cleaning cloth, all-purpose cleaner, or a can of compressed air.

Step 3. Pair the Transfer with the Coaster

Lay the transfer down on a flat surface with the printed image facing up. Place the blank side of the coaster on top of the transfer and line it up. Take two pieces of heat tape and secure the coaster to the transfer.

Note: Depending on the size of your heat press, you can press multiple coasters at once.

Step 4. Let’s sublimate!

Place the transfer and coaster into the heat press with the transfer on top. Lay another piece of protective paper on top of the coaster. Confirm that the heat press is at the correct temperature. Pressing times are below.

Coasters, Raw Back: 60 – 70 seconds
Coasters, Cork Back: 60 – 70 seconds
Coasters, Premium Coasters: 60 – 70 seconds

Step 5. Remove Coaster From the Heat Press

Once the timer is done use heat-protective gloves to remove the coaster from the press. Let cool.

Enjoy your new coaster!

Scroll to Top